Note that I don't want these markings to be saved in the file itself. What I would like is a way to mark the points in each file that should match to help the comparison generate more correct results.Īn alternative, which may work better would be to mark sections of the file to be ignored during the comparison. In many cases this is due to whitespace differences at the start of the line and causes the routine to match a different line with closer whitespace even though the next lines do not match at all. When this occurs it often results in a large section of the code being mismatched. I try to adjust the comparison by adding new lines, or even lines with a special character that cannot match any other line to assist in aligning the match, but it does not always work. Sometimes when I am comparing code, the comparison matches on the wrong if, loop, method, etc. This may be a difficult request, but I hope you like this and can do make it happen.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |